Repair Nokia 6100
Controlling a Nokia 6100 Display with an Atmel-AVRThe Display (which is used in Nokia 6100, 7210, 6610, 7250 and 6220) has a resolution of 132x132 Pxieln @4096 Colors. The visible area is about 3cm x 3cm in size. It can be found cheap at *bay. Note that there exist two types of Displays:
- Green PCB: Epson S1D15G10 Chipset
- Orange/Brown PCB: Philips PCF8833 Chipset
The provided Software does only work with Displays with the Philips chipset. If you want to use a Display with S1D15G10-chipset, take a look 
here.
Hardware
I have used a AVR ATMega8 to control the Display.
The display works at 3,3V. I use a voltage divider (1.8k, 3.3k to GND) to convert the 5V signals of the controller to 3,3V levels for the display.
I directly soldered a ribbon cable on the back side of the display.
Pinout and connection to AVR:
| 1 | VDD 3,3V | |
| 2 | /Reset | PB4 |
| 3 | SDATA | PB3 |
| 4 | SCLK | PB5 |
| 5 | /CS | PB2 |
| 6 | VLCD 3,3V | |
| 7 | NC | |
| 8 | GND | |
| 9 | LED- | |
| 10 | LED+ (6V) | |
| 11 | NC |
no responsibility is taken for the correctness of this information.
Test
With the 8-Bit AVR Microcontroller i have build a rainbow-Animation, a simple oscilloscope and a Wireframe-3D-Engine:
Software
This Software can be compiled with AVR-GCC. It display a test picture first.
It is possible to upload a RAW-RGB-Image-File via the serial interface.
nokia_6100_display_test.zip (41 KB) -
Philips PCF8833 DatasheetEpson S1D15G10 Controller, with an ATMEL AVR ATMega32L
Caution : Beaware no responsibility is taken for the correctness of this information.
0 comments:
Post a Comment